If necessary, you may place a length of cotton between each subsection/parting.Continue this application throughout your four quadrants. Drop the hair without pressing it into the previous section to ensure that the regrowth remains free of product.If you prefer to use your hand to support the subsection, keep a towel nearby to wipe your hands periodically throughout the application. This provides a sturdy surface to allow ease of saturation, and keeps your hands free of product, preventing transfer onto Zones 1 or 3. If this is the case, apply the product through to the ends in this step.You may find it helpful to use a foil/balayage board to support the subsection that you are applying colour to. As mentioned above, not every client will have a Zone 3. Be sure to saturate the hair fully on either side of the subsection/parting to ensure an even colour result. You may choose to use your wider tint brush for this area for maximum efficiency and saturation. We begin in Zone 2 as this area is typically slower to process than Zones 1 and 3. Beginning at the bottom of the quadrant and working upwards, use ¼ inch subsections/partings and apply your colour only to Zone 2, ½ inch to ¾ inch away from the scalp, and through the mid-lengths.Generally, this will be the back two quadrants, as the hair around the face tends to be lighter and easier to lift. Begin your application in the darkest sections.Once you have prepared the client for their colour service, gathered your tools and supplies, and mixed up your oxidative colour formula: Take a moment to consider in which zone you would begin your application, based on the information above… Keep in mind that we are referring to virgin hair in this chapter, so the following does not account for any chemical influences. Section nose to nape, then ear to ear.īefore we get into the application of the oxidative colour, let’s pause for a moment to review the different areas, or zones, of the hair. Section and divide the hair into 4 quadrants using your comb and clips.Brush through the hair to remove tangles.If your client has very long hair, tuck the outside towel in so that it lays lengthwise (see following photo). This provides a surface to lay the coloured hair on, which will keep the colour cape clean. Then, fasten the colour cape loosely, allowing just enough room to tuck a towel into the outside of the cape. First, place a towel around the client’s shoulders. Drape your client using towels and a colour cape. Prepare your client for their oxidative colour lightening service by performing the following procedure: Chapter 4 – Lightening Virgin Hair and RegrowthĤ.3 Application Process: Global Lightening Service – Oxidative Colour Tools and Supplies Required
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |